ie you solder it where the two 68K resistors are joined together for channel 1. then take the other end of the 1Meg resistor and solder it to the junction of the 68K input resistors of CHANNEL 1. The mod itseft:Take a 1 MEG resisitor and solder it to the center wiper. Go to the VOLUME II pot.unsolder the wire in the center terminal of the pot wiper.then solder this wire to GROUND, you can just solder it to the next pin on the same pot that is grounded. 022uF coupling cap.also you should use the tone stack withthe 250pF on the treble with 56K slope resistor.also use. 0022uF for coupling cap and the VOLUME I bright channel should use a. If you want to maximise this mod do a swap of caps before you begin.The VOLUME II channel should use the. This is for Super Lead type amp but you can do it on similar amp also. Is that it? If you are not familiar with the “One Wire” mod, the instructions, taken from another forum are below. All I could think would happen is the 1Meg resistor to ground would get disconnected. I’m trying to figure out how the gain increases using the “One Wire” mod by shoving a guitar chord into channel 1.
0 Comments
Leave a Reply. |